[Virtualacorn-list] VA won't start properly

[Chris Newman]

In article <561717d859dave at triffid.co.uk>,
   Dave Symes <dave at triffid.co.uk> wrote:
> In article <5616FF2F3F%mik.towse at xemik.com>,
>    Mik Towse <mik.towse at xemik.com> wrote:
> > In article <5616b52caccvjazz at waitrose.com> Chris Newman  wrote:
> > > I have a Lenovo laptop with 250 GB SSD. It runs Windows 10 & has VA
> > > 4.39 on a partition. It came from RComp.
> > > 
> > > The SSD  failed & a local firm put in a new one in & reinstalled W10.
> > > The VA stuff was saved.

> [Snip]

> This is a possible answer...

> From the Windows side go the the directory in which you have your VRPC
> installed.
> Open the VRPC Directory
> Open the Models Directory
> Select the Model (Jit) directory used) and open it.

> Open the models.cfg file in a proper text editor.

> Scroll down and find this particular line "mount0 etc".

> This is an extract from my VRPC install.


> [HostFS]
> podule = 0
> mount0 = "HardDisc4 'C:\Apps\VRPC\VirtualRPC-DL620\HardDisc4'
> bootopt=2,showext"

> (The mount line is all one line).

> Check the path written from when it was initially installed (Not copied)
> is the same as the actual path to the place into which it was/is now
> copied.

> If not, then amend the above line to match exactly the new place.
> And Save.

> Hope that sorts your problem.

Thanks for that. I'll have a go tomorrow & report back.







> -- 

> Dave Triffid

-- 
Chris